Filter
Top Products
1-2
Installing the Agilent 8702D
Installing the Agilent 8702D
Installing the Agilent 8702D
The instructions in this chapter show you how to install your Agilent 8702D.
You should be able to finish these procedures in about ten to twenty minutes.
Refer to “Specifications and Regulatory Information”, in the
Agilent 8702D
Reference
manual
,
for information on operating conditions such as tempera-
ture.
If you should ever need to clean the cabinet, use a damp cloth only.
WARNING
Any interruption of the protective conductor inside or outside of the
product is likely to make the product dangerous. Intentional
interruption is prohibited.
CAUTION
This product has autoranging line voltage input. Be sure the supply voltage is
within the specified range.
CAUTION
VENTILATION REQUIREMENTS: When installing the product in a cabinet, the
convection into and out of the product must not be restricted. The ambient
temperature (outside the cabinet) must be less than the maximum operating
temperature of the product by 4
°
C for every 100 watts dissipated in the
cabinet. If the total power dissipated in the cabinet is greater than 800 watts,
then forced convection must be used.
CAUTION
This product is designed for use in INSTALLATION CATEGORY II and
POLLUTION DEGREE 2, per IEC 1010 and 664 respectively.