Filter
Top Products
1-12
Installing the Agilent 8702D
Step 8. Connect a Printer or Plotter
Step 8. Connect a Printer or Plotter
1
Connect a printer or plotter to the corresponding interface port. Refer to
Figure 1-6 on page 1-10 for the appropriate rear panel connection.
2
If you are using the parallel interface, press
LOCAL
and then
PARALLEL
until
COPY
appears.
The
GPIO
selection dedicates the parallel port for general purpose I/O. The
Agilent 8702D controls the data input or output through the sequencing capa-
bility of the instrument.
3
If you are using an GPIB printer or plotter, press
LOCAL
,
SYSTEM CONTROLLER
to
set up the Agilent 8702D as the controller.
Printer Interface Recommended Cable
Parallel Agilent 92284A
Serial Agilent 24542G
GPIB Agilent 10833A/B/D