Mitsubishi Electronics Q173HCPU Baby Accessories User Manual


 
6 -
231
6 POSITIONING CONTROL
6.24 High-Speed Oscillation
Positioning of a specified axis is caused to oscillate on a sine wave.
Items set by peripherals
Common OSC Parameter block Others
Servo instruction Positioning method
Number of
controllable axes
Parameter block No.
Axis
Address/travel value
Command s
p
eed
Dwell time
M-code
Tor
q
ue limit value
Startin
g
an
g
le
Amplitude
Fre
q
uenc
y
Control unit
S
p
eed limit value
Acceleration time
Deceleration time
Ra
p
id sto
p
deceleration time
Tor
q
ue limit value
Deceleration
p
rocessin
g
on sto
p
in
p
ut
Allowable error ran
g
e for circular inter
p
olation
S-curve ratio
Cancel
WAIT-ON/OFF
Speed change
OSC
1
Invalid
: Must be set
: Set if required
[Control details]
The designated axis caused to oscillate on a specified sine wave.
Acceleration/deceleration processing is not performed.
360[degree]
Starting angle
Amplitude
(1) Amplitude
Set the amplitude of the oscillation in the setting units.
The amplitude can be set within the range of 1 to 2147483647.
(2) Starting angle
Set the angle on the sine curve at which oscillation is to start.
The setting range is 0 to 359.9 [degree]
(3) Frequency
Set how many sine curve cycles occur in one minute.
The setting range is 1 to 5000 [CPM].
POINT
Since acceleration/deceleration processing is not performed, you should set the
starting angle to 90 or 270 [degree] in order to avoid an abrupt start.