Mitsubishi Electronics Q173HCPU Baby Accessories User Manual


 
6 -
204
6 POSITIONING CONTROL
(4) Cautions
(a) Home position return and continuously start of home position return are also
possible in the proximity dog ON in the count type 1.
When the home position return or continuously start of home position return
are executed in the proximity dog ON, the home position return is executed
after return the axis once to position of the proximity dog OFF.
(b) When the zero point is not passed (zero pass signal: M2406+20n ON) until it
travels the distance set in the "travel value after proximity dog ON" from
home position return start, a minor error "ZCT not set" (error code: 120) will
occur, a deceleration stop is made and home position return does not end
normally. When a distance between home position return start position and
home position is near and a zero point is not passed, select the count type 3.
(c) When the "travel value after proximity dog ON" is less than the deceleration
distance from "home position return speed" to "creep speed", a minor error
"an overrun occurred because the setting travel value is less than the
deceleration distance at the proximity dog signal input during home position
return of count type" (error code: 209) will occur and deceleration stop is
made.
(d) If in-position signal (M2402+20n) does not turn ON, home position return is
not ended.