Filter
Top Products
5. Base Specifications Parameters
53
# Items Details
Setting range (unit)
1265
(PR)
ext01
(bit0)
Command
format
Select the command format.
0: Conventional format
0
1266
(PR)
ext02 Not used.
1267
(PR)
ext03
(bit0)
G code type Select the G code type.
This parameter is valid when 1 is set in "#1265 ext01 bit
0 (command format)".
0/1
1268
(PR)
ext04 Not used.
1269
(PR)
ext05 Not used.
1270
(PR)
ext06 Not used.
1271
(PR)
ext07
(bit0)
Mirror image
operation
Select the type of mirror image operation. Not applied
to this CNC.
0: Type 1
• The program mirror image, external mirror
image, and parameter mirror image are
exclusive to each other.
• An increment command moves the image to
the position indicated by the move amount with
the sign inverted.
1: Type 2
• Mirror image operation is enabled when the
program mirror image (G51.1) command is
issued or when the external signal or
parameter is ON.
• An increment command moves the image to
the position determined by applying the mirror
image to the absolute program coordinates.
0/1
(Default: 0)
ext07
(bit1)
Address
specifying
fixed-cycle
repetition
count (For M
system only)
Specify the address that specifies the fixed-cycle
repetition count. Not applied to this CNC.
0: Address L only
1: Addresses K and L
If addresses K and L are specified simultaneously, the
data at address K is used for operation.
0/1
(Default: 0)
ext07
(bit2)
F-command
unit
Specify the unit to be used if a thread cutting read
command contains on decimal point. Not applied to this
CNC.
0: Type 1 (conventional specifications)
F1 → 1 mm/rev, 1 inch/rev
1: Type 2
F1 → 0.01 mm/rev, 0.0001 inch/rev
0/1
(Default: 0)