Filter
Top Products
5. Base Specifications Parameters
19
# Items Details
Setting range (unit)
1039 spinno Number of
spindles
Specify the existence of a spindle.
0: No spindle 4: Four spindles
1: One spindle 5: Five spindles
2: Two spindles 6: Six spindles
3: Three spindles 7: Seven spindles
0 to 7
1040
(PR)
M_inch Constant
input (inch)
Specify the parameter unit system for the position and
length.
0: Metric system
1: Inch system
1041
(PR)
l_inch Initial state
(inch)
Specify the unit system for the program movement
amount when the power is turned on or reset and for
position display.
0: Metric system
1: Inch system
1042
(PR)
pcinch PLC axis
command
(inch)
Specify the unit system for the commands to the PLC
axis.
0: Metric system
1: Inch system
1043 lang Select
language
displayed
Specify the display language.
0 : Japanese display
1 : English display
21: Polish display
(Note) If no character package is available for a
specified language, the screen is displayed in
English.
0/1/21
1044
(PR)
auxno MR-J2-CT
connections
Specify the number of MR-J2-CT axes connected.
As for C6/C64 system, up to 5 axes of MR-J2-CT can
be connected, thus, the setting range is 0 to 5.
0 to 7
(Note) Selection of inch and metric unit
When set value of "#1041 I_inch" is changed‚ the unit of length is changed after reset.
Among parameters concerning length‚ following items are not changed automatically‚ therefore
change the set values to agree with the new unit system when the unit system is changed.
Tool compensation amount
(Tool length compensation amount‚ tool wear compensation amount and tool tip compensation amount)
Workpiece coordinate offset
Machining parameter #8004 SPEED #8013 G83n #8052 PULL UP
#8005 ZONE r #8016 G71 MINIMUM #8053 G73U
#8006 ZONE d #8017 G71 DELTA-D #8054 W
#8009 DSC. ZONE #8018 G84/G74n #8056 G74 RETRACT
#8010 ABS. MAX. #8027 Toler-1 #8057 G76 LAST-D
#8011 INC. MAX. #8028 Toler-2
#8012 G73n #8051 G71 THICK
Axis parameter #8204 OT-CHECK-N
#8205 OT-CHECK-P
#8206 TOOL CHG.P
#8209 G60 Shift
Barrier data #8300 – #8306
Basic specification
parameter
#1084 RadErr
#8004 SPEED is 10 inches/min. unit for the inch system.