Filter
Top Products
5. Base Specifications Parameters
22
# Items Details
Setting range (unit)
1066
JOG_HP
Select JOG
activation
(+) device
Specify the number of the device that inputs +JOG
activation signals. The device type is specified by
"#1071 JOG_D". The effective range of set values vary
depending on the device type. A value outside of the
effective range is invalid if specified.
(Note) The setting range of this parameter has been
expanded on the software Ver.D0 and later.
X: 0000 to 03FF
(hexadecimal)
M: 0000 to 8191
(decimal)
1067
JOG_HN
Select JOG
activation
(−) device
Specify the number of the device that inputs -JOG
activation signals. The device type is specified by
"#1071 JOG_D". The effective range of set values vary
depending on the device type. A value outside of the
effective range is invalid if specified.
(Note) The setting range of this parameter has been
expanded on the software Ver.D0 and later.
X: 0000 to 03FF
(hexadecimal)
M: 0000 to 8191
(decimal)
1068
(PR)
slavno Slave axis
number
Specify the axis number of a slave axis to be
synchronized. The axis number is an NC number
excluding the spindle and PLC axis.
Two or more slave axes cannot be set up for one
master axis.
This parameter "slavno" cannot be set up for a slave axis.
A multiple part system cannot be set up so that the
relation between the master and slave axes extends
over a part system.
0: No slave axis
1 to 6: First to
sixth axes
1069
(PR)
no_dsp Axis with no
counter
display
Set up an axis that displays no counter. This option is
valid on the counter display screen (e.g. POSITION
screen).
0: Displays the
counter
1: Does not
display the
counter.
1070 axoff Axis
removal
Define an axis that enables axis removal control. 0: Disables axis
removal.
1: Enables axis
removal
1071
(PR)
JOG_D
±JOG
activation
signal
device
name
Specify the number of the device that inputs ±JOG
activation signals.
0 : X device
1 or 2: M device
Set the JOG_HP (#1066) and JOG_HN (#1067)
parameters according to this device specification
parameter.
(Note) The setting range of #1066 and #1067
parameters has been expanded on the software
Ver.D0 and later.
0 to 2