Filter
Top Products
5. Base Specifications Parameters
51
# Items Details
Setting range (unit)
1229 set01
(bit2)
Radius
compen-
sation type B
(For M
system only)
0: When the start-up and cancel commands are
operated during radius compensation, their blocks
are not handled by intersection operation
processing; they are handled as offset vectors in the
direction vertical to that of the commands.
1: When the start-up and cancel commands are
operated during radius compensation, the inter-
section operation processing of the command
block and the next block is executed.
0/1
Nose R
compen-
sation type B
(For L
system only)
0: When the start-up and cancel commands are
operated during nose R, their blocks are not
handled by intersection operation processing; they
are handled as offset vectors in the direction
vertical to that of the commands.
1: When the start-up and cancel commands are
operated during nose R, the intersection operation
processing of the command block and the next
block is executed.
0/1
set01
(bit3)
Initial
constant
surface
speed
0: The initial state after power-on is a constant
surface speed control cancel mode.
1: The initial state after power-on is a constant
surface speed control mode.
0/1
set01
(bit4)
Synchronous
tap
0: Handles the tap cycles as the tap cycles with a
floating tap chuck.
1: Handles the tap cycles as the tap cycles without a
floating tap chuck.
0/1
set01
(bit5)
Start point
alarm
Select an operation when the operation start point
cannot be found while moving the next block of G117.
0: Enables an auxiliary function after the block has
been moved.
1: Outputs a program error (P33) when the
operation start point is not found.
0/1
set01
(bit6)
Grid display
selection
Select a grid type to be displayed on the servo monitor
screen during dog type reference point return.
0: Selects the distance between dog ON and
reference point (including a grid mask amount).
1: Selects a value given by reducing a grid mask
amount from the distance between dog ON and
reference point.
0/1
1230 set02 Not used.
1231 set03 Not used.
1232 set04 Not used.
1233 set05 Not used.