Filter
Top Products
Software Installation
AUDIX Voice Power Switch Integration Software R2.1.1
(Please see the Switch Notes for your telephone system for the
exact name of this software package.)
Remote Terminal Package
NOTE:
If you are upgrading AUDIX Voice Power from a previous release,
see Chapter 5, Upgrade Procedures, before proceeding. The
upgrade procedure will refer you to the necessary sections in this
chapter.
If you are adding AUDIX Voice Power to an existing system, or if you are
reinstalling application software after an unrecoverable failure, the UNIX
operating system must be reinstalled before you can install or reinstall
AUDIX Voice Power.
Verifying Hard Disk Size
Before beginning the software installation, you should verify the size of the
hard disk. To determine the hard disk size, follow these steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Insert the Customer Test disk supplied with the system into drive A.
Boot the system by turning power ON or by pressing (Reset) if the
system is already on.
The system boots from the Customer Test disk and displays the
Customer Test introduction screen.
Press (Enter) to continue.
The Customer Test main menu appears.
Use to move the cursor to
Setup utility
and press (Enter).
Record the
hard disk size
for later use.
Press (Esc) to exit.
Move the cursor to
Exit the program
and press (Enter).
At the
Want to Quit?
prompt, select
Yes
and press (Enter).
Remove the Customer Test disk.
3-3