Filter
Top Products
Software Installation
Testing the IVP4 Switch Settings
After setting the switches on each board correctly, to verify the
correctness of the switch settings, go to Step 4 of the Determining the
IVP4 Board by Testing section in Chapter 2.
DCP Conflict
If your system includes a DCP board, you must disable serial port 2.
There is a conflict between the DCP board and the hardware used for
serial port 2. To disable serial port 2, follow these steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Log in as root (if not already logged in).
At the # prompt, type
face
and press (Enter).
The AT&T FACE menu appears.
At the AT&T FACE menu, select
System Administration
and
press (Enter).
The System Administration menu appears.
At the System Administration menu, select
Peripherals
Setup
and press (Enter).
The Peripheral Setup menu appears.
At the Peripheral Setup menu, select
Enable/Disable Second
Serial Port
and press (Enter).
The Enable/Disable Second Serial Port menu appears.
At the Enable/Disable Second Serial Port menu, select
Disable
Second Serial Port
and press (Enter).
The second serial port is disabled.
The system will show a confirmation screen telling you to reboot
the system as soon as possible.
Press [F3] (CONT).
When prompted for a shutdown, press (Enter) to shut down the
system.
When prompted to reboot, press (Ctrl) + (Alt) + (Del)
simultaneously.
3-45