Filter
Top Products
Hardware Installation
DCP Board
Configuration and Installation
Your system may be shipped with the DCP board installed. If you need to
add the DCP board to the system, follow these steps:
1.
Check the jumpers on the DCP board. The jumpers should be set
as shown in Figure 2-29.
Figure 2-29. Location of Jumpers on DCP Board
2.
Carefully insert the board in its proper location. The board goes
into the leftmost available slot (after the IVP4 boards) on desktop
configurations and into the rearmost available slot (after the IVP4
boards) on floor models.
2-49