Filter
Top Products
Software Installation
2.
3.
4.
5.
NOTE:
If the system configuration includes a tape drive or multiple
floppy disk drives, additional prompts may appear. Use the
preceding steps as a guide to responding to the system
prompts. The actual prompts may vary depending on the
system configuration.
Insert the Switch Integration Software disk into the floppy disk drive
and press (Enter).
Depending on which telephone system you have, you maybe
asked which version of the switch you are using.
If asked, indicate the version of the switch and press (Enter).
Files are listed on the screen as they are moved to the hard disk.
When all copying has been completed, you are prompted to
remove the disk.
NOTE:
If the package will not load because of a conflict error, verify
that serial port 2 is disabled. You should have disabled this
port when you installed the Integrated Voice Power system
software. If this is the reason for the conflict, see DCP
Conflict at the end of the chapter for instructions on disabling
serial port 2.
If this problem persists, call the next tier of support for
assistance.
After the installation has completed, remove the diskette.
If prompted for shutdown, press (Enter) to shut down the
system. When you are prompted to reboot the system,
press (Ctrl) + (Alt) + (Del) simultaneously.
3-34