Filter
Top Products
Hardware Installation
7.
8.
9.
10.
11.
You can see that Card 0 has an O.S. Index number of 1.
Card 1 has an O.S. Index number of 2. Therefore, you
need to change the DIP switch setting for Card 0, which is
the first board. Determine if the settings for Card 0 match
Configuration
B
or
C
in Figure 2-28. If the settings match
Configuration
B,
change the settings to those of
Configuration
C.
If they match Configuration
C,
then change
the settings to those of Configuration
B.
Proceed to Step 7.
Shut down the system and turn the power OFF.
Open the case and change the DIP switches.
Close the case and turn the power ON.
Follow the procedure outlined in Renumbering Voice Channels
which immediately follows.
Now that you have renumbered the channels, you want to verify
the status of the boards. Follow the instructions in Step 4. If the
board is still not recognized properly and you have determined that
the slide switches do not appear to be the problem, call the next
tier of support for assistance.
Renumbering Voice Channels
After you have reset the board switch settings, you must administer the
changes in the AUDIX Voice Power system. Follow the steps below to
accomplish this.
1.
2.
3.
Log into the system as audix.
At the User Login menu, move the cursor to
Voice System
Administration
and press (Enter).
— The Voice System Administration window appears.
Move the cursor to Configuration Management and press
(Enter).
— The Configuration Management window appears.
2-47