Filter
Top Products
Software Installation
Acceptance testing should follow these steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Run any diagnostics available on the analog and digital switch
boards and lines including verification of dial tone at the jacks
where AUDIX Voice Power will be connected, and including ring
checks to verify the assigned extension numbers.
Run the Power On Self-Test on the processor by turning it on.
See Power On Self-Test in Chapter 4.
Run the general diagnostics on the Customer Test disk according
to the instructions given in General Diagnostics in Chapter 4.
Establish that dial tone can be detected on all Integrated Voice
Power channels by running the IVP4 diagnostics according to the
instructions given in IVP4 Board Diagnostics in Chapter 4.
Verify the IVP4 switch settings are correct using the procedure
Testing the /VP4 Switch Settings in Chapter 4.
Administer the switch for two test users for voice (Voice1 and
Voice2).
NOTE:
The customer may supply real names and extension
numbers for testing if this is more convenient.
Administer AUDIX Voice Power for the two test voice users.
See the AT&T AUDIX™ Voice Power System Manager's Guide
for instructions.
Run the call-through test on all analog ports.
Call the system and create personal greetings for test users.
Call the system and leave messages for test users.
Call the system and retrieve messages for test users.
Send and receive voice mail between test users.
These tests provide a good measure of overall system operation.
3-44