Filter
Top Products
Upgrade Procedures
To upgrade from AUDIX Voice Power Release 1.1 to Release 2.1.1, it is
necessary to first upgrade from Release 1.1 to Release 2.0, and then to
upgrade from Release 2.0 to Release 2.1.1.
The procedure for upgrading from AUDIX Voice Power Release 1.1 to
Release 2.0 is described in the following section. The procedure for
upgrading from AUDIX Voice Power Release 2.0 to Release 2.1.1 is
described later. If you are upgrading from Release 1.1, continue with the
following section. If you are upgrading from Release 2.0, skip to the
appropriately titled section.
Upgrading from Release 1.1 to Release 2.0
The procedure for upgrading from AUDIX Voice Power Release 1.1 to
Release 2.0 is outlined below. The exact procedure for each step is
included in the step or described elsewhere, either in this chapter, or in
other parts of this document. Note that you must reinstall the UNIX
system as part of this procedure.
1.
Using FORM A from the AT& T AUDIX™ Voice Power Planning
Guide and Forms (Release 2.1. 1), record the current Service Type
and Extension for each channel. To determine the current Service
Type and Extension, you must display the Voice Equipment
window, as described in the chapter Assigning Services to
Channels in your Switch Notes document. For each channel, write
down the Service Type (the Service field on the Voice Equipment
window). After the upgrade is complete, you reassign Service
Types and Extensions to all channels.
2. Log into the system as root.
3. Insert the AUDIX Voice Power Upgrade Utility disk into
the disk drive.
5-2