Filter
Top Products
Hardware Installation
Diagnostics
The only diagnostics that can be run at this time are those provided on the
Customer Test disk for testing the basic system integrity. Additional
diagnostics for the IVP4 boards cannot be run until the software is
installed.
To run the Customer Test diagnostics, follow these steps:
1.
2.
3.
4.
5.
Insert the Customer Test disk supplied with the system into floppy
disk drive A.
NOTE:
Be sure to shut down the UNIX system before rebooting.
Boot the system by turning power ON or by pressing (Reset) if the
power is already on.
The system boots from the Customer Test disk and displays the
Customer Test introduction screen.
Press (Enter) to continue.
— The Customer Test main menu appears.
Use to move the highlight bar to System Checkout or Test
All Modules
(the command displayed depends on the processor
that you are using) and press (Enter).
NOTE:
If
Test All Modules appears on the main menu,
Customization Screen
will also appear. On the
Customization Screen
the interactive mode must be set
to
on
before you select
Test All Modules
if the speaker
test, floppy disk drive test, keyboard keystrokes and
typematic tests, and mouse tests are to be performed. If the
interactive mode is
off,
these tests will not be performed.
Follow the directions on the screen to run the diagnostics.
2-65