Filter
Top Products
Hardware Installation
Connecting Voice and Data Lines
Voice lines must be connected to the IVP4 board(s) and a data line must
be connected to the DCP board if it is used.
Connecting the IVP Voice Lines
Each IVP4 board has two 6-position modular jacks. Each of these
modular jacks is
used to
connect two voice lines in the RJ14C
configuration. The top jack is used for line pairs 1 and 2. The bottom jack
is used for line pairs 3
and 4.
If the line pairs are run two per jack (RJ14C), use two standard,
4-conductor modular cables.
If the line pairs are run individually (RJ11
C), a
type 884A adapter maybe
used to consolidate the four individual line pairs into two pairs (RJ14C) in
each of two cables.
CAUTION:
There is a magnet on the back of the 884A adapter. Be sure that
you
do not
place this near the hard disk drive or floppy disks.
2-59