Filter
Top Products
Hardware Installation
Running SETUP from a Floppy Disk
To run the SETUP program from a floppy disk, follow these steps:
1.
Shut down the UNIX system before rebooting.
2.
Insert the Customer Test disk supplied with the system into drive A.
If running SETUP on a 6386 or 6386E, use the Customer
Diagnostics disk instead of the Customer Test disk.
3.
Boot the system by turning power ON or by pressing the (Reset)
button if the system is already on.
4. Press
The system boots from the Customer Test disk and displays
the Customer Test introduction screen.
(Enter) to continue.
The Customer Test main menu appears.
2-56