Filter
Top Products
Hardware Installation
Opening the 6386E/33 WGS
Follow these steps to remove the cover:
1.
2.
3.
4.
5.
6.
7.
8.
Be sure the system power is turned OFF. If any cables have been
connected to the system module, disconnect them.
Unlock the cover lock. (A set of keys is packed in a plastic bag in
the carton with the system module.)
Remove the top cover
(B)
of the system by lifting from the rear.
Loosen the cover-securing screw
(A)
as shown in Figure 2-6.
Slide the cover
(C)
off the chassis by moving it forward.
Refer to Figure 2-7. Remove the four retaining screws
(A)
from the
card cage cover.
Slide the card cage cover
(B)
forward and then away from the
chassis.
If you are installing additional memory on the motherboard,
disconnect all cables that cover the air deflector
(C).
Then remove
the air deflector by lifting it gently outward to release it from the
chassis.
2-11