Filter
Top Products
Hardware Installation
Connecting the Printer
One parallel printer cable is required to connect the printer.
Follow these steps to connect the printer:
1.
2.
3.
4.
Unpack and set up the printer according to the instructions in the
documentation supplied with the printer. Do
not
plug in the printer.
Connect the 25-pin DB25 connector end of the parallel printer
cable to the parallel port on the WGS system module. The cable
connector has pins and the WGS connector has sockets. Secure
the connector with the captive screws.
Connect the other end of the parallel printer cable to the matching
Centronics® port (Amphenol connector) on the printer. Use the
spring clips to secure it.
Plug in the printer.
2-64