Filter
Top Products
Hardware Installation
Setting the Control Values
Follow this procedure to set the control values on the report printer:
1.
Unpack and set up the printer according to the instructions in the
documentation supplied with the printer.
2.
Be sure that the printer has paper, the ribbon is properly installed,
and the cover is closed. The printer will not enter Set Up Mode if it
is out of paper or if the cover is open.
3. Set the default values by following these steps:
a. While holding down the [Function] and [Scroll v] switches,
turn the power ON. When the SELF TEST functions
complete, setup function number 99 is automatically
displayed.
b. Press the [Scroll ^] switch to select setup function number
98 (set default values).
c. Press the [Menu] switch to enter Menu Mode.
d. Press the [Scroll v] switch to select menu item 02.
e. Press the [Function] switch once to set the default values.
f. Turn the power OFF.
2-63