Filter
Top Products
Hardware Installation
VDC600Board
Configuration and Installation
The VDC600 is the AT&T equivalent of a Video Graphics Array (VGA)
board.
NOTE:
The 6386/SX WGS has a video controller built into the
motherboard. The VDC600 should not be used with the
6386/SX WGS.
The VDC should be installed in the leftmost expansion slot on desktop
configurations or in the rearmost expansion slot on floor models. Follow
the general instructions for installing expansion boards described in
General Installation Instructions, later in this chapter.
NOTE:
The VDC600 must be installed in a 16-bit expansion slot.
The default settings are used for the DIP switch and jumpers on the Video
Display Controller. The locations and settings are shown in Figure 2-24.
For more information on default settings, see the Video Display Controller
lnstallation Guide packed with the board.
2-36