Filter
Top Products
Upgrade Procedures
b.
c.
d.
e.
NOTE:
If the system configuration includes a tape drive or
multiple floppy disk drives, additional prompts may
appear. Use the preceding steps as a guide to
responding to the system prompts. The actual
prompts may vary depending on the system
configuration.
Insert the Switch Integration software disk into the floppy
disk drive and press (Enter).
Depending on which telephone system you have, you may
be asked which version of the switch you are using.
If asked, indicate the version of the switch and press
(Enter).
Files are listed on the screen as they are moved to the hard
disk. When all copying has been completed, you will be
prompted to remove the disk.
NOTE:
If the package will not load because of a conflict error,
verify that serial port 2 is disabled.
If this problem persists, call the next tier of support for
assistance.
After the installation has completed, remove the disk.
If prompted for shutdown, press (Enter) to shut down the
system. When you are prompted to reboot the system,
press (Ctrl) + (Alt) + (Del) simultaneously.
10.
Install the remote access software (if not already loaded). Follow
the procedure in Installing Software for Remote Access in
Chapter 3.
5-28