Filter
Top Products
Software Installation
Installing Cartridge Tape Utility Software
If you
Utility
have a cartridge tape drive, you must
software.
NOTE:
The tape drive is not compatible with the DCP board.
install the Cartridge Tape
Use the following procedures to install the cartridge tape utility software:
1.
Log in as root (if you are not already logged in).
2.
At the # prompt, type installpkg and press (Enter).
For systems with an installed tape drive:
.
— The system displays
Please indicate the installation medium
you intend to use.
Strike C to install from CARTRIDGE TAPE
or F to install from FLOPPY DISKETTE.
Strike ESC to stop.
— Type f.
For systems with more than one floppy disk drive:
— The system displays
This system has two floppy drives.
Strike ENTER to install from drive 0 or
1 to install from drive 1.
—
Type 1 and press (Enter) to select drive 1, or just press
(Enter) to select drive 0.
NOTE:
If the system configuration includes a tape drive or multiple
floppy disk drives, additional prompts may appear. Use the
preceding steps as a guide to responding to the system
prompts. The actual prompts may vary depending on the
system configuration.
3-35