Filter
Top Products
Optional Hardware and Software M400E Ozone Analyzer Operator’s Manual
5.2. RACK MOUNT KITS (OPT 20 TO OPT 23)
There are several options for mounting the analyzer in standard 19” racks. The slides are three-part extensions,
one mounts to the rack, one mounts to the analyzer chassis and the middle part remains on the rack slide when
the analyzer is taken out. The analyzer locks into place when fully extended and cannot be pulled out without
pushing two buttons, one on each side.
The rack mount brackets for the analyzer require that you have a support structure in your rack to support the
weight of the analyzer. The brackets cannot carry the full weight of an analyzer and are meant only to fix the
analyzer to the front of a rack, preventing it from sliding out of the rack accidentally.
OPTION NUMBER DESCRIPTION
OPT 20A Rack mount brackets with 26 in. chassis slides.
OPT 20B Rack mount brackets with 24 in. chassis slides.
OPT 21 Rack mount brackets only
Opt 23 Rack Mount for External Pump Pack (No Slides)
5.3. CARRYING STRAP HANDLE (OPT 29)
The chassis of the M400E analyzer allows the user to attach a strap handle for carrying the instrument. The
handle is located on the right side and pulls out to accommodate a hand for transport. When pushed in, the
handle is nearly flush with the chassis, only protruding out about 9 mm (3/8”).
Figure 5-1: M400E with Carrying Strap Handle and Rack Mount Brackets
Installing the strap handle prevents the use of the rack mount slides, although the rack mount brackets, Option
21, can still be used.
CAUTION
General Safety Hazard
A FULLY LOADED M400E WITH BOTH THE O
3
GENERATOR AND PHOTOMETER
OPTIONS INSTALLED WEIGHS ABOUT 17 KG (40 POUNDS).
TO AVOID PERSONAL INJURY WE RECOMMEND TWO PERSONS LIFT AND CARRY
THE ANALYZER.
MAKE SURE TO DISCONNECT ALL CABLES AND TUBING FROM THE ANALYZER
BEFORE CARRYING IT.
46 04315 Rev. C1