Filter
Top Products
M400E Ozone Analyzer Operator’s Manual Introduction
1.3. USING THIS MANUAL
NOTE
Throughout this manual, words printed in capital, bold letters, such as SETUP or ENTR represent
messages as they appear on the analyzer’s display.
This manual is organized in the following manner:
TABLE OF CONTENTS:
Outlines the contents of the manual in the order the information are presented. This is a good overview of the
topics covered in the manual. There is also a list of appendices, figures and tables.
SECTION I – GENERAL INFORMATION
INTRODUCTION
A brief description of the M400E analyzer architecture as well as a description of the layout of the manual
and what information is located in its various sections and chapters.
SPECIFICATIONS AND WARRANTY
A list of the analyzer’s performance specifications and if applicable a description of the conditions and
configuration under which EPA equivalency was approved as well as the Teledyne Instruments’ warranty
statement.
GETTING STARTED
Instructions for setting up, installing and running your analyzer for the first time.
GLOSSARY:
Answers to the most frequently asked questions about operating the analyzer and a glossary of
acronyms and technical terms.
OPTIONAL HARDWARE & SOFTWARE
A description of optional equipment to add functionality to your analyzer.
SECTION II – OPERATING INSTRUCTIONS
BASIC OPERATION OF THE M400E ANALYZER
Step-by-Step instructions for using the display/keyboard to set up and operate the M400E analyzer.
ADVANCED FEATURES OF THE M400E ANALYZER
Step-by-Step instructions for using the M400E analyzer’s more advanced features such as the iDAS
system, the DIAG and VARSmenus and the and the TEST channel analog output.
REMOTE OPERATION OF THE M400E Analyzer
Information and instructions for interacting with the M400E analyzer via its several remote interface
options (e.g. via RS-232, Ethernet, its built in digital control inputs/outputs, etc.)
M400E VALIDATION AND VERIFICATION
Methods and procedures for verifying the correct operation of your M400E Analyzer as well as step by
step instructions for calibrating it
EPA PROTOCOL CALIBRATION
Specific information regarding calibration requirements for analyzers used in EPA monitoring.
04315 Rev. C1 5