Filter
Top Products
M400E Ozone Analyzer Operator’s Manual 357BRemote Operation Of The M400E
To assign or reset the status flag bit assignments, press:
DEL deletes the
character currently
inside the cursor
brackets.
Press the [?] key repeatedly to cycle
through the available character set: 0-9
NOTE: Values of A-F can also be set
but are meaningless.
The <CH and CH>
keys move the cursor
brackets “[ ]”
left and right along the
bit string.
SETUP X.X HESSEN STATUS FLAGS
<SET SET> EDIT EXIT
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2 EXIT
SETUP X.X HESSEN VARIATION:TYPE1
<SET SET> EDIT EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE RANGE=500.0 PPB O3= XXXX
<TST TST> CAL SETUP
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
Continue pressing NEXT until ...
SETUP X.X O3 GEN REF WARNING:0010
PREV NEXT EDIT PRNT EXIT
SETUP X.X BOX TEMP WARNING:[0]010
<CH CH> INS DEL [0] ENTR EXIT
SETUP X.X BOX TEMP WARNING:0010
PREV NEXT EDIT PRNT EXIT
Continue pressing NEXT until desired
flag message is displayed
EXIT discards the
new setting
ENTR accepts the
new setting
INS Inserts a the
character at the
current location of the
cursor brackets.
8.5.8. INSTRUMENT ID CODE
The M400E analyzer is programmed with a default ID code of 400.
Each instrument on a Hessen Protocol network must have a unique ID code. If more than one M400E analyzer
is on the Hessen network, you will have to change this code for all but one of the M400E analyzer’s on the
Hessen network (see Section 8.1.6).
04315 Rev. C1 147