Filter
Top Products
357BRemote Operation Of The M400E M400E Ozone Analyzer Operator’s Manual
When COM2 is configured for RS-485 operation the port uses the same female DB-9 connector on the back of
the instrument as when Com2 is configured for RS-232 operation, however, the pin assignments are different.
Female DB-9
(
COM2
)
(As seen from outside analyzer)
(RS-485)
1 234 5
6 7 8 9
GND
RX/TX
+
RX/TX
-
Figure 8-6: Back Panel connector Pin-Outs for COM2 in RS-485mode.
The signal from this connector is routed from the motherboard via a wiring harness to a 6-pin connector on the
CPU card, CN5.
CN5
(Located on CPU card)
(As seen from inside analyzer)
2 4 6
1 3 5
RX/TX
+
RX/TX
-
GND
Figure 8-7: CPU connector Pin-Outs for COM2 in RS-485 mode.
NOTE:
The DCE/DTE switch has no effect on COM2.
132 04315 Rev. C1