Filter
Top Products
357BRemote Operation Of The M400E M400E Ozone Analyzer Operator’s Manual
Table 8-5: LAN/Internet Configuration Properties
PROPERTY DEFAULT STATE DESCRIPTION
DHCP STATUS
On Editable
This displays whether the DHCP is turned ON or OFF.
INSTRUMENT
IP ADDRESS
Configured by
DHCP
EDIT key
disabled when
DHCP is
ON
This string of four packets of 1 to 3 numbers each (e.g.
192.168.76.55.) is the address of the analyzer itself.
GATEWAY IP
ADDRESS
Configured by
DHCP
EDIT key
disabled when
DHCP is
ON
A string of numbers very similar to the Instrument IP
address (e.g. 192.168.76.1.) that is the address of the
computer used by your LAN to access the Internet.
SUBNET MASK
Configured by
DHCP
EDIT key
disabled when
DHCP is
ON
Also, a string of four packets of 1 to 3 numbers each (e.g.
255.255.252.0) that defines that identifies the LAN to
which the device is connected.
All addressable devices and computers on a LAN must
have the same subnet mask. Any transmissions sent
devices with different subnet masks are assumed to be
outside of the LAN and are routed through a different
gateway computer onto the Internet.
TCP PORT 3000
Editable, but
DO NOT
CHANGE
This number defines the terminal control port by which
the instrument is addressed by terminal emulation
software, such as Internet or Teledyne Instruments’
APICOM.
HOST NAME M400E
Editable
The name by which your analyzer will appear when
addressed from other computers on the LAN or via the
Internet. While the default setting for all Teledyne
Instruments M400E analyzers is “M400E”, the host name
may be changed to fit customer needs.
1
Do not change the setting for this property unless instructed to by Teledyne Instruments Customer Service
personnel.
NOTE
If the gateway IP, instrument IP and the subnet mask are all zeroes (e.g. “0.0.0.0”), the DCHP was not
successful in which case you may have to configure the analyzer’s Ethernet properties manually.
See your network administrator.
134 04315 Rev. C1