Filter
Top Products
M400E Ozone Analyzer Operator’s Manual Getting Started
3.4.4.2. Pneumatic Set Up for M400E’s Monitoring Remote Locations
In this application is often preferred that the Sample gas and the source gas for the O
3
generator and internal
zero air be the same chemical composition.
Figure 3-13: Gas Line Connections when the M400E Analyzer is Monitoring a Remote Location
1. SAMPLE GAS SOURCE: Attach a sample inlet line leading from the room being monitored to the
sample inlet fitting.
2. DRY AIR SOURCE: Attach a gas line leading from the room being monitored to the dry air inlet port.
This can be a separate line or, as shown above the same line with a T- fitting.
3. EXHAUST OUTLET: No outlet line is required for the exhaust port of the instrument.
4. Once the appropriate pneumatic connections have been made, check all pneumatic fittings for leaks
using the procedures defined in Section 12.3.4.
USER NOTES:
04315 Rev. C1 25