Renesas R5S72643 Doll User Manual


  Open as PDF
of 2152
 
R01UH0134EJ0400 Rev. 4.00 Page 2067 of 2108
Sep 24, 2014
Item Page Revision (See Manual for Details)
9.4.3 CSn Space Wait
Control Register (CSnWCR)
(n = 0 to 6)
(3) SDRAM
CS3WCR
272
Table amended
Bit Bit Name
Initial
Value
R/W Description
4, 3 TRWL[1:0]* 00 R/W ...
Cycle number from the issuance of the WRITA
command by this LSI u ntil the completion of auto-
precharge in the SDRAM.
Equivalent to the cycle nu mber from the issuance
of the WRITA command until the issuance of the
ACTV command. Confirm that how many cycles
are required between the WRITA command
receive in the SDRAM and the auto-precharge
activation, referring to each SDRAM data sheet.
And set the cycle number so as not to exceed the
cycle number specified by this bit.
Cycle number from the issuance of the WRIT
command until the issuance of the PRE
command. This is the case when accessing
another low address in the same bank in bank
active mode.
9.5.5 MPX-I/O Interface 301 Description added
The data cycle is the same as that in a normal space
access.
The delay cycles specified by SW[1:0] are inserted
between the Ta3 and T1 cycles. The delay cycles specified
by HW[1:0] are added after the T2 cycle.
Figure 9.11 (1) Access
Timing for MPX Space
(Address Cycle No Wait,
Data Cycle No Wait)
302 Figure title amended
Figure 9.11 (2) Access
Timing for MPX Space
(Address Cycle No Wait,
Assert Extension Cycle 1.5,
Data Cycle No Wait, Negate
Extension Cycle 1.5)
303 Figure added