Filter
Top Products
LED indicators 34
Model 1001MC Operations Guide 2 • Hardware installation
Installing the RS-232 configuration/daisy-chain port cable
The DB-25 connector is a DTE-configured RS-232 port that is used to set up your IP address, subnet mask,
and default configuration. After the system is set up, the configuration port can be used to connect to a Model
1001CC in a separate rack if you are daisy-chaining multiple racks.
Figure 13. RS-232 DTE configuration port
Note The configuration port on your 1001MC, being a DTE, requires a
null modem or equivalent cable when connecting to a terminal.
Using personal computer communications software (Procomm, Windows Terminal, BitCom, PC Anywhere,
etc.), set the configuration of your communications software to the following parameters:
• Data Rate: 19,200 bps
• Async. Character Format: 8 Data Bits, 1 Stop Bit, No Parity
• Terminal Emulation: VT-100 (or similar) terminal emulation
LED indicators
The 1001MC front card has status LEDs (see figure 14) that display at-a-glance the current operational status
of the 1001MC.
Figure 14. Front card LEDs