Filter
Top Products
Model 2701RC Configuration Slot X page MIB variables description 148
Model 1001MC Operations Guide 7 • Model 2701RC management
• lal(4)
• lalWithpat(5)
• lalWithpate(6)
• rdl-v54(7)
• rdl-v54Withpat(8)
• rdl-v54Withpate(9)
• rdl-csu(10)
• rdl-csuWithpat(11)
• rdl-csuWithpate(12)
• rdl-remote(13)
SW Test Mode (testModeSet2701RC)
This displays any test mode invoked through the NMS. See next configuration for information about invoking
test modes through the NMS. This option will be highlighted in blue if the unit is in test mode.
• off(1)-No test mode in process
• pat(2)—Pattern generator (511) turned on
• pate(3)—HPattern generator with errors (511/E) turned on
• lal(4)—Local loopback test
• lalWithpat(5)—Local loopback test with (511) pattern generator
• lalWithpate(6)—Local loopback test with (511/E) pattern generator with errors
• rdl-v54(7)—Remote loopback test from V54
• rdl-Withpat(8)—Remote loopback test with 511 from V54
• rdl-Withpate(9)—Remote loopback test with errors (511E) from V54
RDL Response (v54Loop)
This displays if the unit will respond to a V.54 loop up command (enabled) or if the unit will ignore a V.54
loop up command (disabled).
FP Switches (frntSwitch)
This displays if the front panel toggle switches used for loopbacks and pattern generators are enabled or disabled.
Pattern Select (patternSelect)
This displays the pattern (511, 2047, QRSS) that is used when the pattern generator and detector are turned on.
Loop Time Out (loopTo)
This displays the amount of time that the unit responding to a Remote Loop command will remain in test
mode when the RL test mode is invoked. If the unit is not taken out of test mode by the menu within this time