Filter
Top Products
Model 2701 Configuration page MIB variables description 150
Model 1001MC Operations Guide 7 • Model 2701RC management
Configuration Type (configType)
This displays if the 2701RC is using the DIP switch control or software control for its configuration.
Channel Assignment (dsoEnableCh1…dsoEnableCh31)
If the 2701RC is operating in G.704 channelized mode, a configurable Channel Assignment table appears.
When line format is set to frame-G704(1), individual channels can be either enabled(1) or disabled(0). These
options cannot be accessed if line format is set to frame-G703(0).
Note Timeslot 0 (Channel 1) is reserved for synchronization when G.704
is enabled therefore, this channel cannot be accessed. Also, if CAS
multiframing is enabled, Channel 16 cannot be accessed because it is
used for signaling with CAS is enabled.
Unit Configuration table
This table shows the configurable MIB variables for the set of units. After changes are made, select the Submit
Query button at the bottom of the table and then place the Input Mode back to onLine(0) in the Model 2701
Configuration page.
The following sections explain the MIB variables that are shown in the Unit Configuration table.
Line Format (lineFormat)
This option is used to set the line format to the following:
• frame-G703(0)—G.703 unframed
• frame-G704(1)—framed G.704
Clock Mode (clockMode2701RC)
This variable defines the clock mode for the NetLink-E1 modems. The following options are available:
• network-CLK(0)
• internal-CLK(1)
• external-CLK(2).
DTE Rate (dteRate2701RC)
This read-only variable displays the DTE rate for the link. This is the Nx64 kbps data rate selected by the
number of activated channels.
Line Coding (lineCoding2701RC)
This variable is used to select the G.703 line coding. The following options are available:
• code-HDB3(0)—HDB3
• code-AMI(1)—AMI