Filter
Top Products
Model 2701RC Configuration Slot X page MIB variables description 147
Model 1001MC Operations Guide 7 • Model 2701RC management
Line Format (lineFormat)
The following status variables can be displayed:
• unframe-G703(0)—Sets the line format to G.703 unframed
• frame-G704(1)—Sets the line format to framed G.704
Clock Mode (clockMode2701RC)
This variable defines the clock mode for the NetLink-E1 modems. The following status variables can be dis-
played:
• network-CLK(0)
• internal-CLK(1)
• external-CLK(2)
DTE Rate (dteRate2701RC)
This variable displays the DTE rate for the link. This is the Nx64 kbps data rate selected by the number of acti-
vated channels.
Line Coding (lineCoding2701RC)
The following status variables can be displayed:
• AMI line coding
• HDB3 line coding.
CRC4 Framing (crc)
This displays if CRC-4 framing is enabled or disabled.
CAS Multiframing (casMF)
This displays if CAS multiframing is enabled or disabled.
Line Build Out (lineBuildOut)
This displays the selected line build out: either 75 ohm or 120 ohm.
Tx Clock Timing (txClock)
This displays whether the serial transmit data coming from the DTE is clocked in using the DCE provided
transmit clock or DTE provided external clock.
SW/HW Test Mode (testModeSetInd)
This displays any test mode invoked from the toggle switches, DTE test mode lines, or from the web manage-
ment page. This option will be highlighted in blue if the unit is in test mode. In the status of the parameter,
SW means initiated via the web management page or HW means initiated from the toggle switches or DTE
test mode interface signals on the remote standalone unit.
• off(1)
• pat(2)
• pate(3)