Filter
Top Products
Slot Configuration page MIB variables description 185
Model 1001MC Operations Guide 8 • Model 2707RC management
Loop Timeout (loopTo)
This selects the amount of time that the unit will remain in test mode when the remote test mode is invoked.
If the responding unit is not taken out of test mode within this time period, the unit will automatically time
out and return to normal data mode.
Test Mode from DTE (testModeDTE)
When enabled, the 2707RC will respond to the LL signal coming from the DTE.
Config Type (configType)
The following options are available:
• switch-config(0)—The 2707RC is using the DIP switch control for its configuration
• software-config(1)—The 2707RC is using the software control for its configuration
User Id (UserID)
Displays the user-supplied string that defines the NetLink modem installed in the rack. The string is stored in
non-volatile flash within the NetLink modem and is useful for hardware identification. If the address of the
modem is changed, the User ID will move to the new slot. The string can be up to 10 bytes long and can be
changed or reset within the
Slot Configuration page.
Slot Configuration page MIB variables description
This section describes the MIB variables that are available on the Slot Configuration page. From the Modem
Information page, the address column creates a list of hyperlinks to the Slot Configuration page associated with
the specified address. The
Slot Configuration page can be used to set slot-specific information related to the sys-
tem and how the system treats the slot in the case of errors and warning.
Note The information contained here is also available in the Model
1001MC manual and is listed here for ease of use.
Card Address (nmsSlotID)
Displays the address of the card.
Local Model Code (localModelCode)
Displays the model code of the NetLink modem installed at the specified address.
View Rack X hyperlink
Click on the View Rack X link to display the Modem Information Rack X window (see section “Modem Infor-
mation Rack X” on page 239 for more information).
Card Identification Information
Local User Id (localUserID)
User supplied string that defines the NetLink NTU installed in the rack. The string is stored in non-volatile
flash within the NetLink NTU and is useful for hardware identification. If the address of the modem is
changed, the User ID will move to the new slot. The string can be up to 10 bytes long and can be changed or
reset within this page.