Filter
Top Products
Modem Information Rack X 240
Model 1001MC Operations Guide 10 • HTTP/HTML web page reference
Rack Protection Mode
If you want to protect all Model 1095RC, 2701RC, and 2707RC rack cards installed in the current rack from
being globally configured, select protected(1) from the pop-up menu, then click the
Submit button. For more
information about the system configuration feature, refer to section “System Config” on page 259.
Note Setting the Rack Protection Mode to normal(0) will enable the rack to
receive new configurations through the global configuration command.
Submit button
After you have defined the number of power supplies installed in the rack and the rack protection mode, click
on the
Submit button to save the changes.
Power Supply 1 Status
Displays the current status of power supply 1 as one of the following:
• available(0)—The power supply is working normally.
• down(1)—If the status is shown as down, it means the 1001MC is unable to detect the power supply. This
status listing will also be highlighted in red.
• notInstalled(2)—The power supply has not been installed.
Power Supply 2 Status
Displays the current status of power supply 2 as one of the following:
• available(0)—The power supply is working normally.
• down(1)—If the status is shown as down, it means the 1001MC is unable to detect the power supply. This
status listing will also be highlighted in red.
• notInstalled(2)—The power supply has not been installed.
Clear Rack X Alarms (clearAlarms)
Click on this button to clear alarms for the current rack.
Note The System Log will still display the errors after the Clear Rack X
Alarms button is clicked.
Card Address (nmsSlotID)
Defines the address of the card. The Model 1001MC will poll the cards using the addresses listed in the Card
Address column. If a modem is found with the same address, it will be displayed in that row. The address of
the card is setup using the DIP-switches on the card. For more information about setting the address of a card,
please refer to the appropriate NMS version of the manual for the specific NetLink modem. The address is also
a hyperlink to the
Slot Configuration page (see section “Slot Configuration” on page 243 for more informa-
tion). This page can be used to set slot specific information about the card.