Filter
Top Products
Creating and modifying global configuration templates 217
Model 1001MC Operations Guide 9 • Model 3088RC management
1. Select a template from the Modify Configuration pop-up menu (see figure 102), then click the Modify
Configuration button.
2. Change the parameters requiring modification (see figure 103). When you have finished changing the
configuration, click on the Submit button to save the changes.
Refer to section “Applying a template” on page 217 to activate the template.
Deleting a template
Do the following to delete a template:
Note When a template configuration is deleted, it cannot be recovered.
1. Select a template from the Delete Configuration pop-up menu (see figure 102 on page 216).
2. Click the Delete Configuration button.
Applying a template
This section describes how to apply a global configuration to all Model 3088RC rack cards. Model 3088RC
cards which will not be configured to the selected Global Configuration are:
• Those installed in a Model 1001 rack that has the entire rack set to be protected(1)
• Those that are individually set to protected(1) mode
Instructions for protecting either an entire rack or individual 3088RC cards are given earlier in this chapter.
The template can be applied to:
• All 3088RC NTUs in ALL Model 1001 racks
• All 3088RC NTUs in just ONE Model 1001 rack
To configure all Model 3088RC rack cards in all Model 1001 racks
Complete the following steps.
1. Starting from the HOME page, click on the Configure Cards link to display the System Level Information
page see figure 103.