Filter
Top Products
Model 3088RC Configuration page MIB variables description 206
Model 1001MC Operations Guide 9 • Model 3088RC management
Response to Test Mode (responseToTestMode3088RC)
This variable allows or disallows test modes to be initiated front both the front panel or from the remote unit.
• enable(0)
• disable(1)
Software Version (softVersion3088RC)
This displays the software version of code in the 3088RC.
Reset button
Software reset the E-carrier function card on its next poll from 1001MC.
Model 3088RC Configuration page MIB variables description
The Model 3088RC Configuration page enables you to update the configuration of the 3088RC NetLink-E1
NTU modems that are installed in the system. After making changes to the configuration on this page, select
Back to return to the
Model 3088RC Configuration Slot page, then select onLine as the Input Mode, and finally,
select
Submit Query to send the new information to the Model 1001MC over the network. Starting from the
HOME page, click on the following links: Home (menu) > Configure Cards (menu) > View Rack [rack number] >
model3088RC-xxx(x) (in the Local Model Code column) > change input mode to Supervisory > Modify Configura-
tion.
Note If the NetLink-E1 NTU modems are not connected, and changes
made to the remote configuration will be lost after the units link-up.
All parameters in the Local column can be changed at any time.
The following sections describes the MIB variables that are available on the Model 3088RC Configuration—
Configuration page.
DSL Link State (lineStatus3088)
This variable displays the status of the line. There are three possible values that can be displayed:
• success(1) -When the line status is dataMode(2), the units are linked-up and ready to send data
• deactivated (2)
• in-progress (3)
DSL Link State (dSLSyncState3088)
This variable displays the status of the line. There are three possible values that can be displayed:
• acquiring-sync (1)
• in-sync (2)
• losing-sync (3)
Software Version (softVersion3088RC)
This read-only MIB variable displays the current version of code that is running in the NetLink-E1 rack
card modem.