Filter
Top Products
Connecting the cables 33
Model 1001MC Operations Guide 2 • Hardware installation
Connecting a 10Base-T hub to the 1001MC
The Ethernet 10Base-T port on the rear of the 1001MC connects directly to a 10Base-T hub or repeater using
RJ-45 unshielded twisted-pair cable that is wired straight-through (see figure 11).
Note Cable lengths should not exceed 330 feet (100 m) when using Type 4
or 5 cable.
Figure 11. Hub wiring diagram
Connecting a 10Base-T workstation to the 1001MC
The 10Base-T port on the 1001MC connected to a workstation by means of a cross-connect cable. Refer to
figure 12 to build a cross-connect cable that connects between the 10Base-T port on a workstation’s NIC and
the 1001MC’s 10Base-T port.
Note Cable lengths should not exceed 330 feet (100 m) when using Type 4
or 5 cable.
Figure 12. Workstation wiring diagram