Filter
Top Products
Section 26 USB 2.0 Host/Function Module
R01UH0134EJ0400 Rev. 4.00 Page 1359 of 2108
Sep 24, 2014
SH7262 Group, SH7264 Group
Bit Bit Name
Initial
Value R/W Description
6 USBRST 0 R/W Bus Reset Output
Controls the USB bus reset signal output when the
host controller function is selected.
0: USB bus reset signal is not output.
1: USB bus reset signal is output.
When the host controller function is selected, setting
this bit to 1 allows this module to drive the USB port
to SE0 to reset the USB bus. Here, this module
performs the reset handshake protocol if the HSE bit
is 1.
This module continues outputting SE0 while
USBRST is 1 (until 0 is written to USBRST).
USBRST should be 1 (= USB bus reset period) for
the time defined by USB Specification 2.0.
Writing 1 to this bit during communication (UACT =
1) or during the resume process (RESUME = 1)
prevents this module from starting the USB bus reset
process until both UACT and RESUME become 0.
Write 1 to the UACT bit simultaneously with the end
of the USB bus reset process (writing 0 to USBRST).
This bit should be set to 0 if the function controller
function is selected.
5 RESUME 0 R/W Resume Output
Controls the resume signal output when the host
controller function is selected.
0: Resume signal is not output.
1: Resume signal is output.
Setting this bit to 1 allows this module to drive the
port to the K-state and output the resume signal.
This module continues outputting K-state while
RESUME is 1 (until 0 is written to RESUME).
RESUME should be 1 (= resume period) for the time
defined by USB Specification 2.0.
This bit should be set to 1 in the suspended state.
Write 1 to the UACT bit simultaneously with the end
of the resume process (writing 0 to RESUME).
This bit should be set to 0 if the function controller
function is selected.