Filter
Top Products
The Detectors windowFigure 4-3:
Configure the following fields from the Detectors dialog:
• FID Ignition - manual or automatic
• Ignition Attempts
• Wait Time Between Tries
• Igniter ON duration
• Flame ON Sense Temperature
• Flame OUT Sense Temperature
• Electrometer Voltage
Note
If the FID does not show up in the Detectors window, disconnect from MON2020 and turn off the
GC. Inspect the S1 switch, which is located on the half-moon-shaped wire terminal board. The switch
should be set to "ON".
4.4.5 Checking the GC for leaks
Leak checking should be a standard component of any maintenance protocol. See
Section 3.6.1.
Operation and maintenance
4
Operation and maintenance
89