Filter
Top Products
7. Place the nuts with washers on the upper bolts and then tighten all bolts.
WARNING!
Until all bolts are tight, the unit should be supported to prevent unforeseen accidents.
8. Adjust the lower bracket to align the bolts with the plate. Tighten the bolts.
3.2.3 Floor mount
If ‘Floor Mount’ is specified in the sales order, the arrangement comes pre-assembled with
the GC. The arrangement includes an additional support stand that is intended to be
anchored to a floor or an instrument pad. The base rails have holes that are 13.625 inches
(346 mm) apart, side to side, and 16.75 inches (425.5 mm) apart front to back. The holes
are ½-inch in diameter and will accept up to 7/16-inch (or 10 mm) bolts.
Floor mountFigure 3-3:
Installation and setup
32