Filter
Top Products
CAUTION!
Check the unit prior to wiring to determine if it is equipped for DC power. Failure to observe
this precaution may damage equipment.
To connect a 24 VDC power source to the GC, do the following:
1. Locate the plug-together termination block inside the electronics enclosure.
24 VDC power connection on the back planeFigure 3-5:
2. Bring the two leads in through one of the two possible entries on the lower
compartment. Connect to the termination plug provided with the unit. See
Appendix F, drawing #DE- 20993.
Installation and setup
40