Filter
Top Products
Removing a FOUNDATION fieldbus module
Note
Be sure to properly ground yourself before performing this procedure.
To remove the module, do the following:
1. Unscrew the two LOI post tips. The FOUNDATION fieldbus module can now be
detached from the card cage.
2. Remove the two screws that attach the FOUNDATION fieldbus assembly bracket to
the FOUNDATION fieldbus module.
Installing a FOUNDATION fieldbus module
CAUTION!
Be sure to properly ground yourself before performing this procedure.
Note
The GC draws 21 mA from the FOUNDATION fieldbus.
To install a FOUNDATION fieldbus module, do the following:
1. Attach the FOUNDATION fieldbus assembly bracket to the FOUNDATION fieldbus
module by aligning the two holes in the FOUNDATION fieldbus assembly bracket
with the two holes at the bottom of the FOUNDATION fieldbus module and
screwing in the two thumb screws.
2. Attach the FOUNDATION fieldbus assembly bracket to the card cage by aligning the
FOUNDATION fieldbus assembly bracket's second set of holes with the LOI post tip
holes in the card cage.
3. Screw in the LOI post tips.
4. Use the following wiring chart to connect the FOUNDATION fieldbus cable assembly
to the backplane:
Backplane terminal block Post Number Wire
TB15 1 Brown
2 White
3 Green
TB13 3 Red
4 Black
Operation and maintenance
120