Filter
Top Products
Heater/Solenoid board factory jumper settingFigure 4-25:
Base I/O board factory jumper and switch settingsFigure 4-26:
Backplane factory switch settingFigure 4-27:
4.4.14 Communications
The 700XA has four serial communications ports: Port 0, Port 1, Port 2, and Port 3, which is
a dedicated PC-to-GC port. The mode for each of the first three ports can be set to RS232,
RS422, or RS485. These port configurations are normally specified by the customer at the
time of order and then set at the factory, but they can be changed at any time with
MON2020.
Note
The backplane has two switches located at SW1. The first switch is used for starting the DHCP server.
See Section 3.5.8 for more information. The second switch is reserved for future use.
The backplane has two Ethernet ports:
Operation and maintenance
4
Operation and maintenance
111