Filter
Top Products
SW1 switches on the back planeFigure 3-11:
Note
Make sure the SW1 switch is set to off (1) before connecting the GC to your local network;
else, the GC will disrupt the local network's functioning.
3. Wait for 20 seconds and then do the following to ensure that the server has
provided an IP address to the PC:
a. From the PC, go to Start → Control Panel → Network Connections.
b. The Network Connections window lists all Dial-up and LAN / High-Speed Internet
connections installed on the PC. In the list of LAN / High Speed Internet
connections, find the icon that corresponds to the PC-to-GC connection and
check the status that displays beneath the “Local Area Connection”. It should
show the status as “Connected”. The PC is now capable of connecting to the GC.
See Using MON2020 to connect to the GC.
1. If the status is “Disconnected”, it may be that the PC is not configured to accept IP
addresses; therefore, do the following:
4. Right-click on the icon and select Properties. The Local Area Connection Properties
window displays.
5. Scroll to the bottom of the Connection list box and select Internet Protocol (TCP/
IP).
6. Click Properties. The Internet Protocol (TCP/IP) Properties window displays.
Installation and setup
3
Installation and setup
49