Filter
Top Products
Index
IN-17
Catalyst 2960 and 2960-S Switch Software Configuration Guide
OL-8603-09
configuration guidelines 20-16
default configuration 20-16
described 20-14
disabling 20-18
displaying
active IP or MAC bindings 20-22
bindings 20-22
configuration 20-22
enabling 20-17, 20-18
filtering
source IP address 20-15
source IP and MAC address 20-15
on provisioned switches 20-17
source IP address filtering 20-15
source IP and MAC address filtering 20-15
static bindings
adding 20-17, 20-18
deleting 20-18
static hosts 20-18
IP traceroute
executing 38-18
overview 38-17
IP unicast routing
assigning IP addresses to Layer 3 interfaces 34-4
configuring static routes 34-5
disabling 34-4
enabling 34-4
inter-VLAN 34-1
IP addressing
classes 34-4
configuring 34-4
steps to configure 34-3
subnet mask 34-4
with SVIs 34-3
IPv4 ACLs
applying to interfaces 31-18
extended, creating 31-9
named 31-13
standard, creating 31-8
IPv4 and IPv6
dual protocol stacks 35-4
IPv6
addresses 35-2
address formats 35-2
and switch stacks 35-6
applications 35-4
assigning address 35-7
autoconfiguration 35-4
configuring static routes 35-10
default configuration 35-6
defined 35-1
forwarding 35-7
ICMP 35-3
monitoring 35-11
neighbor discovery 35-3
SDM templates 36-1
stack master functions 35-6
Stateless Autoconfiguration 35-4
supported features 35-2
J
join messages, IGMP 22-3
L
LACP
See EtherChannel
Layer 2 frames, classification with CoS 33-2
Layer 2 interfaces, default configuration 12-23
Layer 2 traceroute
and ARP 38-16
and CDP 38-16
broadcast traffic 38-16
described 38-16
IP addresses and subnets 38-16
MAC addresses and VLANs 38-16