Filter
Top Products
39-5
Catalyst 2960 and 2960-S Switch Software Configuration Guide
OL-8603-09
Chapter 39 Configuring Online Diagnostics
Displaying Online Diagnostic Tests and Test Results
This example shows how to display the online diagnostics that are configured on a switch:
Switch# show diagnostic content switch 3
Switch 3:
Diagnostics test suite attributes:
B/* - Basic ondemand test / NA
P/V/* - Per port test / Per device test / NA
D/N/* - Disruptive test / Non-disruptive test / NA
S/* - Only applicable to standby unit / NA
X/* - Not a health monitoring test / NA
F/* - Fixed monitoring interval test / NA
E/* - Always enabled monitoring test / NA
A/I - Monitoring is active / Monitoring is inactive
R/* - Switch will reload after test list completion / NA
P/* - will partition stack / NA
Test Interval Thre-
ID Test Name attributes day hh:mm:ss.ms shold
==== ================================== ============ =============== =====
1) TestPortAsicStackPortLoopback B*N****A** 000 00:01:00.00 n/a
2) TestPortAsicLoopback B*D*X**IR* not configured n/a
3) TestPortAsicCam B*D*X**IR* not configured n/a
4) TestPortAsicRingLoopback B*D*X**IR* not configured n/a
5) TestMicRingLoopback B*D*X**IR* not configured n/a
6) TestPortAsicMem B*D*X**IR* not configured n/a
This example shows how to display the online diagnostic results for a switch:
Switch# show diagnostic result
Switch 1: SerialNo :
Overall diagnostic result: PASS
Test results: (. = Pass, F = Fail, U = Untested)
1) TestPortAsicStackPortLoopback ---> .
2) TestPortAsicLoopback ------------> .
3) TestPortAsicCam -----------------> .
4) TestPortAsicRingLoopback --------> .
5) TestMicRingLoopback -------------> .
6) TestPortAsicMem -----------------> .
This example shows how to display the online diagnostic test status:
Switch# show diagnostic status
<BU> - Bootup Diagnostics, <HM> - Health Monitoring Diagnostics,
<OD> - OnDemand Diagnostics, <SCH> - Scheduled Diagnostics
====== ================================= =============================== ======
Card Description Current Running Test Run by
------ --------------------------------- --------------------- ------
1 N/A N/A
2 TestPortAsicStackPortLoopback <OD>
TestPortAsicLoopback <OD>
TestPortAsicCam <OD>
TestPortAsicRingLoopback <OD>
TestMicRingLoopback <OD>
TestPortAsicMem <OD>
3 N/A N/A
4 N/A N/A
show diagnostic schedule switch [num | all] Display the online diagnostics test schedule.
show diagnostic post Display the results of POST. (The same as the show post
command.)
Table 39-1 show diagnostic Commands
Command Purpose