APPENDIX C
Warranty/Repair Questionnaire
T400, M400E
(04404D, DCN5798)
TELEDYNE INSTRUMENTS CUSTOMER SERVICE
EMAIL: api-customerservice@teledyne.com
PHONE: (858) 657-9800 TOLL FREE: (800) 324-5190 FAX: (858) 657-9816
C-1
CUSTOMER:_______________________________ PHONE: _____________________________________
CONTACT NAME: __________________________ FAX NO. _____________________________________
SITE ADDRESS:____________________________________________________________________________
MODEL TYPE: ______________ SERIAL NO.:_________________ FIRMWARE REVISION:_____________
Are there any failure messages? _______________________________________________________________
_________________________________________________________________________________________
__________________________________________________________________________________________
________________________________________________________________________
(Continue on back if necessary)
PLEASE COMPLETE THE FOLLOWING TABLE:
(
Depending on options installed, not all test parameters shown below will be available in your calibrator)
PARAMETER RECORDED VALUE ACCEPTABLE VALUE
RANGE PPB/PPM
1 – 10,000 PPB
STABIL
<= 0.3 PPM WITH ZERO AIR
O3 MEAS mV
2500 – 4800 mV
O3 REF mV
2500 – 4800 mV
O3 GEN
1
mV
80 mV. – 5000 mV.
O3 DRIVE
1
mV
0 – 5000 mV.
PRES IN-HG-A
~ - 2”AMBIENT ABSOLUTE
SAMPLE FL CM
3
/MIN
800 ± 10%
SAMPLE TEMP ºC
10 – 50 ºC
PHOTO LAMP ºC
58 ºC ± 1 ºC
O3 GEN TMP
1
ºC
48 ºC ± 3 ºC
BOX TEMP ºC
10 – 50 ºC
SLOPE
1.0 ± .15
OFFSET PPB
0.0 ± 5.0 PPB
FOLLOWING VALUES ARE UNDER THE SIGNAL I/O SUBMENU
REF_4096_MV mV 4096mv±2mv and Must be
Stable
REF_GND mV 0± 0.5 and Must be Stable
1
If IZS valve option installed.
Cap the SAMPLE flow inlet and record the flow rate and pressure:
What is sample flow rate _______________ cc/min What is the sample pressure _______________ in-Hg-A
What are the failure symptoms? ________________________________________________________________
_________________________________________________________________________________________
_________________________________________________________________________________________
_________________________________________________________________________________________
06870C DCN6332